How to Repair Auto Body Dents, Eliminating Rust, and Removing Dirt from Car Body

Car Auto Online | How to Repair Auto Body Dents, Eliminating Rust, and Removing Dirt from Car Body | Small Auto Body Repair can be done with a few simple steps. Repairing of dents, rust, or basic scratches may be done with basic car tools and even only with household stuffs. Some repairs are quite difficult and best left to professionals, but small works often require only a basic knowledge of sanding and painting.

Removing Dirt:

1) Dip the sponge into water and get a fine sandpaper especially designed for wet sanding. Soften edges of the scratches after sanding and a wet sponge until its smooth cone is empty of the objectives of the lesion site.

2) Use filler, or body filler, for deep scratches, to fill in the area. Wet sand the area with sandpaper and a sponge till the edge of the putty is smooth in the area.

3) Peel the area around the zero area at least 3 inches of the damaged area before applying a primer to the region within the band.

4) wet sand the area with a sponge and sandpaper once a primer dries.

5) Check the paint codes from the vehicle's original paint touch-up kits available in stores ADF. Once the final paint is applied and dried, sand with grit sandpaper before polishing 1000 wet and shiny.

Repairing Auto Body Dents

1) Drill a hole in the middle of a dents and put 1/16th-inch metal screw into the hole.

2) Take the screw with pliers and pull until the POP of metal fit.

3) Follow the instructions in repairing basic scratch to finalize the works.

Removing Car Body Rust:

1) Use a circular sander to sand the rust to bare metal. If a circular sander is not available, it can be done by hand. Sand until the rusted surface is sanded down to good painting.

2) Drill small holes around the original stain of rust. These holes serve as the basis for a screen of body repair got from an auto supply store.

3) Cut the body repair screen to fit over the rust area, but inside of the holes. Use glue on the repair screen to put it into place.

4) Apply body kit, after the patch has cured. SAND and shape of the area for a smooth adjustment between the repaired area and the original painting. Follow steps 4-6 of the basic scratch section to finish the WORKS.